Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers

Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers
Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers

Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers

For sale is a full exhaust system, in 2 sections. First is the standard headers as fitted to the bike originally - this is in good condition having covered only 5k miles. O2 sensor is included, which is not the original but was fitted to the replacement exhaust I have now fitted to my bike - it was easier to swap the 2 sensors over than re-route the wiring (the donor bike had covered around 12k miles). Note: the end of the headers where it meets the silencer section has been cut to fit the Renegade custom exhaust and is approximately 2 inches shorter - so these headers can not be used with an original exhaust unless you use a custom hanger.

Not too difficult to swap headers over - takes a couple of hours. Second is the Renegade twin high level pipes with all required link sections. These are in fairly good condition, with a couple of minor dents and needing a good clean up. One of the exhaust clamps snapped while being removed, so you will either need a new bolt or better to replace the clamps with nice shiny new ones. Everything need to fit is included - note from the pictures that you will need to modify the underseat plastic section so the can hangars can be mounted on either side - the 2 small pieces of metal are included.

You will also need to think about how your number place and indicators will be mounted - which is a good news really as the standard design is quite clunky. As you can see from the pictures this setup was fitted to a'54 plate Daytona 955i. The slip on section also shows signs of having a gasket in place, so I'd advise having some gasket material to hand. This Renegade system cost a small fortune when new and looks amazing when fitted - the twin exhausts really suit the bike and leave the single swingarm on view. Second note: you will need a custom remap to ensure the bike is running properly after fitting, due to the differences in design between the Renegade and standard setups.

The item "Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers" is in sale since Saturday, August 11, 2018. This item is in the category "Vehicle Parts & Accessories\Motorcycle Parts\Exhausts & Exhaust Systems\Other Exhaust & Systems"." and is located in Bristol.

This item can be shipped to United Kingdom.

  • Modified Item: No
  • Custom Bundle: No
  • Brand: Renegade
  • Non-Domestic Product: No


Triumph Daytona 955i Twin Renegade High Level Exhausts plus headers