Following advantages speak for JMT lithium-ion batteries. Approximately 1/3 of the weight of comparable lead-acid battery. Unbeatable ratio of cost / weight saving.Because in each position can be installed no acid. Balanced discharge / charge of all cells by Balancer.
Fast charging with high charging current (up to 90% in 6 min). Even at high temperatures still good performance up to 60C. Safe technology and high durability. Lead-acid batteries can be used only 30% of their capacity due to the specific properties, while nearly 100% of the capacity can be used in lithium ion batteries. For this reason, lithium batteries JMT versions of the same for the starting power need only 1/3 of the capacity of a comparable lead-acid battery.A steady state of charge of all the cells is also ensured by a built-in processor ("balancer"). The dimensions of the lithium-ion batteries by using adapters correspond to the dimensions of the original lead-acid batteries. Even the connections are identical, so the battery can be replaced without additional adjustments in a few minutes. Please note that the shop only suitable chargers may be used. The maximum recommended charging currents please refer to Technical Data below. Under no circumstances chargers may be used that attempt to desulfate deeply discharged batteries under 10 volts with a voltage of more than 14.9 volts, before they begin the actual charge. The maximum charging voltage of 14.9 volts may be exceeded under any circumstances. JMT use lithium-ion batteries as a cathode material iron phosphate (LiFePO4) and lithium-polymer using the method of manufacture. This allows them to rise even explode either in flames during normal operation. The technology and the manufacturing process ensure the highest safety standards for lithium batteries. 12 V maintenance-free lithium-ion battery. Recommended charging current 5 A. Maximum charge current for fast charging 40 A. JMP battery charger Skan 1.0. With power plug for UK. Microprocessor-controlled high-tech battery latest generation with 8 charge levels.
Both for fast charging of a battery as well as for the long-term maintenance charge. Trickle charge vehicles during the winter. For batteries from 2 Ah to 50 Ah. Low voltage detection: 0.7V. Overload protection, reverse polarity protection.
Dimensions: 180 x 80 x 40 mm. Connection cable: 2.10 m. Adapter cable with eyelets for permanent connection to the battery. Fast and helpful customer service. All other products are sourced from official UK distributors.
High quality spares & parts at affordable prices. We post worldwide on most items. This item is in the category "Vehicle Parts & Accessories\Motorcycle & Scooter Parts & Accessories\Electrical & Ignition Components\Batteries". The seller is "raw-power-motorcycles" and is located in this country: GB. This item can be shipped to United Kingdom.